Re: Vsphere 5.1 Lost access to volume *** due to connectivity issues....
templierспасибо за ответы!на lun1 лежит реплика с vSphere Replication Applianceможет от этого?больше никакой экзотики нет.
View ArticleClik here to view.
Re: vt-d enabled Ivy Bridge motherboard recommendations
Hi gprentice, How to use your log file to successfully install ESXi 5.1 on GA-Z77X-D3H ? I am stuck at Network Adapter Would appreciate your sharing on how to successfully install ESXi 5.1. Thanks
View ArticleRe: Unable to start vCenter
Same problem here, after Windows Update we found this service World Wide Web Publishing service that was taking port 80.PID was showing number (4) and was saying System was taking it, so no luck...
View ArticleRe: How to setup/utilize the two NIC in the physical ESXi server...
Check out the properties of your vSwitch0. Here you can see an example: http://kb.vmware.com/Platform/Publishing/images/1556_1.png In your case make sure both nics are below Active Adapters....
View ArticleRe: Downgrade Esxi 5.0 to 4.1
Thanks a.p for the advice, We purchased Cisco UC Virt. Foundation 3 year subscription according to the PO's BOM (UCSS-U-VMW-FND-3-1). Can we upgrade this license too? I guess this approach sounds bit...
View ArticleRe: Recovering a lost partition table on a VMFS-5 volume with GPT ?
Thank!!!It worked!!!thank again Enrico
View ArticleRe: Downgrade Esxi 5.0 to 4.1
Thanks JCMorrissey, I had two VM's running in 5.0 at the moment, one is version 7 while the other is version 8. I guess the second one will not be able to running in the 4.1 right?
View ArticleRe: Vsphere 5.1 Lost access to volume *** due to connectivity issues....
Не готов сказать.Попробуйте софтварный инициатор или выкинуть iSCSI на стандартный коммутатор.Статья по траблшутингу коннекта до iSCSI через софтварный инициатор тут -...
View ArticleClik here to view.
ESXi 5 VLAN VST mode configuration issue
Hi, im trying to configure 2 vlans 1600 and 1601 for 2 vmsit works fine in VGT mode on portgroup with VLAN ID 4095 here is the config: But i think it would be much better to use VST mode because i have...
View ArticleRe: Downgrade Esxi 5.0 to 4.1
Also watch out for the datastores. vSphere 4.x hosts can´t see / use VMFS5 datastores (which you may already using with vSphere 5.0). I haven´t heard of an way to downgrade VMFS5 to VMFS3. If you have...
View ArticleRe: Downgrade Esxi 5.0 to 4.1
Since you purchased subscription, I'm pretty sure this entitles you to upgrade the vSphere version. I'd suggest you take a look at the "My VMware" portal to see whether the licenses show up with the...
View ArticleClik here to view.
Re: How to setup/utilize the two NIC in the physical ESXi server...
Thanks, Mario I shall try within this week...
View Articlenetapp lun id getting changed after recovery to DR site in SRM 5.1
Dear Team, I am testing Vmware SRM 5.1 with Netapp simulator 8.1.2. The setup is completed and working successfull. But I have one concern after doing the recovey. I am using ISCSI for SAN...
View ArticleCondivisione disco in esxi
Ciao a tutti, vorrei risolvere questo problema ma non so come. Ho un disco sata 2tb (RDM) fisicamente installato in un server esxi 5.1, il disco è condiviso da diverse VM efunziona perfettamente.Ho...
View ArticleRe: Off-site backup with VDP?
Reading through the vSphere Replication documentation, it seems to suggest that I'd need an entire second datacenter, complete with SAN, ESXi Hosts and a vCenter Server. We simply aren't a large enough...
View ArticleRe: 'Optimistic locking failure' after failed clean-up
Hi, Please open an SR (if you haven't already) and upload SRM + vSphere Replication support bundles for both protection and recovery sites.The VRMS logs are needed to troubleshoot the "Optimistic...
View ArticleRe: ESXi 5 VLAN VST mode configuration issue
With VLAN 4095 traffic is passed through to the VMs including the VLAN tag. If you set the VLAN-ID on the port group, the VLAN tag will be removed by the port group already, so you'll have to disable...
View ArticleRe: MSCS, NLB, VmWare vSphere 5 with iSCSI SAN
I am not sure if it's already included in the docs but you should ensure the DRS anti-affinity rules are setup for MSCS VMs which are using in-guest iSCSI Iniator. To ensure both the VMs are not...
View ArticleRe: can i fix it?
Just a word of caution so as not to unrealistically get your hopes up... While replacing the missing extents can at times work, nonetheless it is not an absolute fix in all cases! You have at least 6...
View ArticleRe: Forgot my windows password. VMware fusion on Mac, please help
Get any data off it using a portable HDD, format and reinstall windows.The password you are being asked for is the administrator password.If you dont want to clean install you can try this guide:How to...
View Article